How to factory reset TECNO Spark Go 2024? How to wipe all data in TECNO Spark Go 2024? How to bypass screen lock in TECNO Spark Go 2024? How to restore defaults in TECNO Spark Go 2024?
The following tutorial shows all methods of master reset TECNO Spark Go 2024. Check out how to accomplish Hard Reset by hardware keys and Android 13 Go Edition settings. As a result your TECNO Spark Go 2024 will be as new and your Unisoc T606 UMS9230 cores will run faster.
1. Utilize the Power key for a few moments.
2. Press the Volume Up and Power buttons for a couple of seconds.
3. When the Android Robot image pops up, let go of all keys.
4. As the fourth step, hold down the Power key and click on the Volume Up key once.
5. The Recovery Mode should be on the screen by now.
6. Use the Volume keys to navigate and the Power button to select.
7. Then, go to the Wipe data/factory reset option.
8. Now, select Factory data reset using the same buttons.
9. Choose Reboot system now with the Power key.
Tecno Spark Go (2024) Specification
The phone comes with a 90 Hz refresh rate 6.60-inch touchscreen display offering a resolution of 1612×720 pixels (HD+). It comes with 4GB of RAM. The Tecno Spark Go (2024) runs Android 13 (Go Edition) and is powered by a 5000mAh non-removable battery.
As far as the cameras are concerned, the Tecno Spark Go (2024) on the rear packs 13-megapixel camera. It has a single front camera setup for selfies, featuring an 8-megapixel sensor.