How to factory reset TECNO Spark Go 2022? How to wipe all data in TECNO Spark Go 2022? How to bypass screen lock in TECNO Spark Go 2022? How to restore defaults in TECNO Spark Go 2022?
The following tutorial shows all method of master reset TECNO Spark Go 2022. Check out how to accomplish hard reset by hardware keys and Android 11 Go Edition settings. As a result your TECNO Spark Go 2022 will be as new and your Mediatek MT6761D Helio A20 core will run faster.
1. Start by pushing the Power button for a few moments to turn off your mobile.
2. Then hold down Volume Up and Power key for a short while.
3. Let go of the Power button when the TECNO logo shows up.
4. When the Android Robot image pops up release Volume Up.
5. Now click Volume Up + Power key together to open Recovery Mode.
6. In the next step select Wipe data/factory reset. Use Volume buttons to navigate and the Power key to accept it.
7. After that go to Factory data reset by using the same keys as before.
8. At the end, choose Reboot system now with the Power button.
9. Well done! All your data will be removed during the operation.
Tecno Spark Go 2022 specification:
The phone comes with a 6.52-inch touchscreen display with a resolution of 720×1600 pixels and an aspect ratio of 20:9. It comes with 2GB of RAM. The Tecno Spark Go 2022 runs Android 11 (Go edition) and is powered by a 5000mAh battery.
As far as the cameras are concerned, the Tecno Spark Go 2022 on the rear packs a 13-megapixel camera with an f/1.8 aperture. The rear camera setup has autofocus. It has a single front camera setup for selfies, featuring an 8-megapixel sensor with an f/2.0 aperture.