How to factory reset TECNO Spark Go 1? How to wipe all data in TECNO Spark Go 1? How to bypass screen lock in TECNO Spark Go 1? How to restore defaults in TECNO Spark Go 1?
The following tutorial shows all methods of master reset TECNO Spark Go 1. Check out how to accomplish Hard Reset by hardware keys and Android 14 Go Edition settings. As a result your TECNO Spark Go 1 will be as new and your Unisoc Tiger T615 cores will run faster.
1. Start by fully powering off your device.
2. Press and hold both the Power and Volume Up buttons at the same time.
3. When you see a robot icon with the No command message, press and hold the Power button and quickly tap the Volume Up button.
4. The Recovery mode screen will now appear.
5. Use the Volume buttons to navigate, and press the Power button to confirm a selection.
6. Select the Wipe data/factory reset option.
7. Confirm by choosing Factory data reset.
8. To finish, select Reboot system now.
Tecno Spark Go 1 Specification:
The phone comes with a 120 Hz refresh rate 6.67-inch display offering a resolution of 720×1600 pixels. Tecno Spark Go 1 is powered by an octa-core Unisoc T615 processor. It comes with 4GB of RAM. The Tecno Spark Go 1 runs Android 14 GO and is powered by a 5000mAh battery. The Tecno Spark Go 1 supports proprietary fast charging.
As far as the cameras are concerned, the Tecno Spark Go 1 on the rear packs 13-megapixel camera. It has a single front camera setup for selfies, featuring an 8-megapixel sensor.