How to factory reset TECNO Spark 8? How to wipe all data in TECNO Spark 8? How to bypass screen lock in TECNO Spark 8? How to restore defaults in TECNO Spark 8?
The following tutorial shows all method of master reset TECNO Spark 8. Check out how to accomplish hard reset by hardware keys and Android 11 settings. As a result your TECNO Spark 8 will be as new and your Mediatek MT6762V/WD Helio P22 core will run faster.
1. At start, press the Power button for a few seconds to turn off your TECNO Spark 8.
2. After that hold down Volume Up + Power key for a couple of seconds.
3. If you see the TECNO logo on the screen release the Power button.
4. Let go of Volume Up when the Android Robot image appears.
5. Now click Volume Up + Power key together to open Recovery Mode.
6. In the next step go to Wipe data/factory reset. Use Volume buttons to navigate and the Power key to accept it.
7. After that choose Factory data reset by using the same keys as before.
8. At last, select Reboot system now with the Power button.
9. Well done! All your data will be removed during the whole operation.
Tecno Spark 8 Specification:
Tecno Spark 8 mobile was launched on 13th September 2021. The phone comes with a 6.20-inch touchscreen display with a resolution of 720×1600 pixels at a pixel density of 269 pixels per inch (ppi) and an aspect ratio of 20:9. Tecno Spark 8 is powered by an octa-core MediaTek Helio A25 processor. It comes with 2GB of RAM. The Tecno Spark 8 runs Android 11 (Go edition) and is powered by a 5000mAh battery.
As far as the cameras are concerned, the Tecno Spark 8 on the rear packs a 16-megapixel (f/1.8) + AI Lens camera with an f/1.8) + AI Lens (f/2.0 aperture. The rear camera setup has autofocus. It has a single front camera setup for selfies, featuring an 8-megapixel sensor with an f/2.0 aperture.