How to factory reset TECNO Camon 30 Pro 5G? How to wipe all data in TECNO Camon 30 Pro 5G? How to bypass screen lock in TECNO Camon 30 Pro 5G? How to restore defaults in TECNO Camon 30 Pro 5G?
The following tutorial shows all methods of master reset TECNO Camon 30 Pro 5G. Check out how to accomplish Hard Reset by hardware keys and Android 14 settings. As a result your TECNO Camon 30 Pro 5G will be as new and your MediaTek Dimensity 8200 Ultra cores will run faster.
1. Begin by turning off your mobile device using the Power key.
2. Next, press and hold the Volume Up and Power buttons simultaneously until the TECNO logo appears. Release the Power button, but continue holding the Volume Up button.
3. If you see an Android Robot image on the screen, release the Volume Up button, then press it again along with the Power key to enter Recovery Mode.
4. Use the Volume buttons to navigate to the Wipe data/factory reset option, then press the
Power key to confirm your selection.
5. Next, navigate to and select Factory data reset using the Power key to confirm.
6.Finally, select Reboot system now using the Power key to restart your device.
7. Well done! Your mobile device has been successfully factory reset.
Tecno Camon 30 Pro 5G Specification:
The phone comes with a 144 Hz refresh rate 6.78-inch touchscreen display offering a resolution of 1080×2436 pixels (FHD+). Tecno Camon 30 Pro 5G is powered by an octa-core MediaTek Dimensity 8200 processor. It comes with 12GB of RAM. The Tecno Camon 30 Pro 5G runs Android 14 and is powered by a 5000mAh non-removable battery. The Tecno Camon 30 Pro 5G supports proprietary fast charging.
As far as the cameras are concerned, the Tecno Camon 30 Pro 5G on the rear packs a triple camera setup featuring a 50-megapixel primary camera; a 50-megapixel camera, and a 2-megapixel camera. It has a single front camera setup for selfies, featuring a 50-megapixel sensor.