How to factory reset TECNO Spark 8 Pro? How to wipe all data in TECNO Spark 8 Pro? How to bypass screen lock in TECNO Spark 8 Pro? How to restore defaults in TECNO Spark 8 Pro?
The following tutorial shows all method of master reset TECNO Spark 8 Pro. Check out how to accomplish hard reset by hardware keys and Android 11 settings. As a result your TECNO Spark 8 Pro will be as new and your MediaTek Helio G85 core will run faster.
1. At the very beginning, press the Power key for a few seconds to turn off your phone.
2. After that hold down Volume Up and Power button for a short while.
3. Let go of the Power button when the TECNO logo appears.
4. When Android Robot image pops up on the screen release Volume Up.
5. Then click Volume Up and Power key once to enter Recovery Mode.
6. Now choose Wipe data/factory reset. Use Volume buttons to move and the Power key to accept it.
7. Next, go to Factory data reset with the same buttons.
8. At the end, select Reboot system now by using the Power key.
9. Well done! All your data will be removed during this operation.
Tecno Spark 8 Pro specification:
The phone comes with a 6.80-inch touchscreen display with a resolution of 1080×2460 pixels. Tecno Spark 8 Pro is powered by an octa-core MediaTek Helio G85 processor. It comes with 4GB of RAM. The Tecno Spark 8 Pro runs Android 11 and is powered by a 5000mAh battery.
As far as the cameras are concerned, the Tecno Spark 8 Pro on the rear packs a triple camera setup featuring a 48-megapixel primary camera with an f/1.79 aperture, and a 2-megapixel camera with an f/2.4 aperture. It has a single front camera setup for selfies, featuring an 8-megapixel sensor.