How to factory reset TECNO Spark 6 Go? How to wipe all data in TECNO Spark 6 Go? How to bypass screen lock in TECNO Spark 6 Go? How to restore defaults in TECNO Spark 6 Go?
The following tutorial shows all methods of master reset TECNO Spark 6 Go. Check out how to accomplish Hard Reset by hardware keys and Android 10 Go Edition settings. As a result your TECNO Spark 6 Go will be as new and your Mediatek MT6761D Helio A20 cores will run faster.
1. Start by holding down the Power button for a few moments to turn off your smartphone.
2. Then press Volume Up and Power key for a couple of seconds.
3. Let go of the Power button when the TECNO logo appears.
4. When the Android Robot picture shows up release Volume Up.
5. Now click Volume Up + Power key together to open Recovery Mode.
6. In the next step select Wipe data/factory reset. Use Volume buttons to navigate and the Power key to accept it.
7. After that go to Factory data reset with the same keys as before.
8. At the end, choose Reboot system now by using the Power button.
9. Wonderful! You are performed hard reset operation.
The phone comes with a 6.52-inch touchscreen display offering a resolution of 720×1600 pixels at a pixel density of 269 pixels per inch (ppi) and an aspect ratio of 20:9. Tecno Spark 6 Go is powered by a 1.8GHz octa-core MediaTek Helio A25 processor. It comes with 4GB of RAM. The Tecno Spark 6 Go runs Android 10 and is powered by a 5000mAh battery.
As far as the cameras are concerned, the Tecno Spark 6 Go on the rear packs 13-megapixel + AI lens camera. The rear camera setup has autofocus. It sports an 8-megapixel camera on the front for selfies.