How to factory reset MOTOROLA Edge 50 Fusion? How to wipe all data in MOTOROLA Edge 50 Fusion? How to bypass screen lock in MOTOROLA Edge 50 Fusion? How to restore defaults in MOTOROLA Edge 50 Fusion?
The following tutorial shows all methods of master reset MOTOROLA Edge 50 Fusion. Check out how to accomplish Hard Reset by hardware keys and Android 14 settings. As a result your MOTOROLA Edge 50 Fusion will be as new and your Qualcomm SM6450 Snapdragon 6 Gen 1 cores will run faster.
1. First, Power Off your device.
2. Next, simultaneously press and hold the Power and Volume Down buttons until your mobile enters Bootloader Mode.
3. Use the Volume Rocker to navigate and select Recovery Mode, then press the Power key to confirm.
4. When the Android Robot image appears, press the Volume Up button while holding down the Power key.
5. Now, you should see the Recovery Mode on your screen.
6. Navigate to “Wipe data/factory reset” using the Volume buttons and select it with the Power button.
7. Then choose “Factory data reset” from the menu and confirm it with the Power button.
8. Finally, select “Reboot system now” using the Power button.
Motorola Edge 50 Fusion Specification:
The phone comes with a 144 Hz refresh rate 6.70-inch touchscreen display offering a resolution of 2400×1080 pixels (FHD+) at a pixel density of 395 pixels per inch (ppi) and an aspect ratio of 20:9. It comes with 8GB, 12GB of RAM. The Motorola Edge 50 Fusion runs Android 14 and is powered by a 5000mAh battery. The Motorola Edge 50 Fusion supports 68W Turbo Charge fast charging.
As far as the cameras are concerned, the Motorola Edge 50 Fusion on the rear packs a dual camera setup featuring a 50-megapixel primary camera, and a 13-megapixel camera. It has a single front camera setup for selfies, featuring a 32-megapixel sensor.