How to factory reset MOTOROLA Edge 40? How to wipe all data in MOTOROLA Edge 40? How to bypass screen lock in MOTOROLA Edge 40? How to restore defaults in MOTOROLA Edge 40?
The following tutorial shows all methods of master reset MOTOROLA Edge 40. Check out how to accomplish Hard Reset by hardware keys and Android 13 settings. As a result your MOTOROLA Edge 40 will be as new and your Mediatek Dimensity 8020 cores will run faster.
1. Let’s disable the MOTOROLA Edge 40 by using the Power key.
2. Push and hold the Power button with the Volume Down simultaneously.
3. After a while, the Bootloader mode will be activated.
4. Use the Volume rocker to move to the Recovery mode position and click the Power key to continue.
5. Then, to skip the No command step, you should press once the Volume Up while holding the Power button.
6. All right, use the same keys as previously to pick the Wipe data/factory reset operation.
7. Select the Factory data reset option to begin the process.
8. In the end, use the Reboot system now method.
9. Good job!
Motorola Edge 40 Specification.
The phone comes with a 144 Hz refresh rate 6.50-inch touchscreen display offering a resolution of 2400×1080 pixels (FHD+) at a pixel density of 402 pixels per inch (ppi) and an aspect ratio of 20:9.Motorola Edge 40 comes with 8GB of RAM. The Motorola Edge 40 runs Android Android 13 and is powered by a 4500mAh non-removable battery. The Motorola Edge 40 supports wireless charging.
As far as the cameras are concerned, the Motorola Edge 40 on the rear packs a dual camera setup featuring a 50-megapixel (f/f/1.4, 1.0 µm-micron) primary camera, and a 13-megapixel (f/f/2.2, 1.2 µm-micron) camera. It has a single front camera setup for selfies, featuring a 32-megapixel sensor with an f/f/2.4 aperture and a pixel size of 0.7 µm-micron.